Drywall Corner Bead Types

Published: 12th May 2010
Views: N/A

When you install drywall in your home, it is important not to neglect the installation of drywall corner bead. Is put drywall corner bead over drywall in the corners, and is used to protect it from damage. Bead and a certain type of corner installation will depend on the details of your drywall. Because there is a wide range of types of grain angle, the option may seem intimidating. However, armed with the knowledge of the difference between these different species, and will be able to choose the best one.

Metal corner bead



Traditionally, the drywall corner bead of metal. In particular, galvanized steel, the traditional materials for the selection of a grain corner. It is light, and resist corrosion well.

Plastic corner bead



Plastic corner bead Last of metal and has many advantages. Plastic is more flexible than steel, and therefore can be used with the alignment minus the wood more easily. In addition, if the wood warps after the installation of the plastic corner bead will be able to deal with change more easily.

Corner bead standard L-shaped



Standard grain corner L-shaped is the most common variety of grain corner. It is available in either metal or plastic, called the angle of 90 degrees.



L-shaped corner bead often comes with the tape attached paper. This makes installation much simpler. It is available in lengths of 8-10 feet, and measures 11 / 4 inches by 11 / 4 inches.

Standard corner bead aisle



Standard corner bead corner of the corridor is similar to L-shaped bead. However, it is one of the special features that distinguish them and makes it ideal for curved surfaces. Grain of the corridor corner and cuts and put in in the 1.2-inch intervals. This increases the degree to which can bend, making it more capable of dealing with archways and curves again.



Standard corner bead aisle, unlike the pill at such an angle L is only available in plastic, not metal.

Bullnose corner bead aisle



Bullnose corner bead corridor uses a similar strategy to pass the standard angle bead. Like a standard pill path angle, and cut it in the 1.2-inch intervals to allow greater flexibility and tolerance curves. In addition, only available in plastic, metal and reduce the importance of the benefits of the design.



However, bead, bead bullnose corner of the corridor comes in 03/04 from 03/04 inch measurements, unlike the wider angle standard. In addition, it has been specifically designed to reduce the appearance of the importance of angles.



Bullnose corner bead is available in the corridor 8 or 10 foot lengths.

Bullnose corner bead



Bullnose corner bead uses the same stylistic features and the corridor bullnose corner bead, but was designed and functional to work with straight lines instead of curves. Corner of the corridor, such as a grain of the same design, and dimensions of 03/04 of 03/04 inches, and comes in 8 or 10 foot lengths. However, it can be made of plastic and metal alike. Bullnose corner bead is ideal if you want to round the corners of your walls.

http://www.prohometips.com/ carries free home improvement advice, great remodeling tips , and appliance buying guides by leading home improvement authority, DIY expert and HGTV personality

For further detail about visit our website: http://www.prohometips.com/




Report this article Ask About This Article


Loading...
More to Explore